Gear train

126 Pins
·
5y
Fast and Fresh
Squareness comparator I finished building today. I was planning to use 1/2” steel ball bearings for the feet and face but didn’t I didn’t have any in stock. Impatience caused me to improvise! I put a slight radius on some steel rod with my radius turning tool and sanded with progressively finer grit until I got the finish I wanted, then parted off at 1/2”. Reamed holes at .499” then discovered the stock I used is slightly undersized anyways, so had to cement the ...
Collet Holding Block
Picture
Collet Holding Block
Picture
Collet Holding Block
Picture
Collet Holding Block
Picture
Collet Holding Block
Picture
Collet Holding Block
Picture
Collet Holding Block
Picture